Tile Cleaning
HOW TO CARE FOR YOUR TILE BEFORE A PROFESSIONAL CLEANING IS NEEDED
WHEN YOUR GROUT BECOMES DARK AND REGULAR MOPPING NO LONGER DOES THE JOB, IT’S TIME TO CALL CRYSTAL CARPET & TILE CLEANERS!
- Purchase a good quality dust mop and sweep your ceramic tile floors daily. This is especially important in new installations where the grout has not fully cured. Dirt, mud, and sand tend to get ground into the grout mortar from heavy foot traffic.
- Dirt collecting carpet mats should be placed in frequently used entrances and shaken out weekly.
- We do not recommend the use of floor waxes as they can be difficult to remove from ceramic tile floors. As long as your floor is properly sealed and maintained, you should find no need for these products.
- Shower stall and tub enclosures should have proper ventilation. Stagnant water breeds stain causing mildew as well as other fungi.
- Many tile cleaners are acid based and their use should be limited. Always read the manufacturers label to find out. All acids, no matter how weak, will etch marble surfaces. Natural marble is commonly installed as thresholds in doorways and is also installed in windowsills and shower curbs. In addition, avoid any cleaner that contains harsh abrasives.
- Mop or sponge your tile down 2 to 3 times weekly. Mix 1 capful of dishwashing liquid per gallon of hot water. Mop up excess water and allow to dry. Buffing with a dry towel will help to reduce spotting.
WHEN YOUR GROUT BECOMES DARK AND REGULAR MOPPING NO LONGER DOES THE JOB, IT’S TIME TO CALL CRYSTAL CARPET & TILE CLEANERS!
How do we clean your tile?
Step 1 – Visual inspection. We will join you in the inspection to be sure that there are no damaged grout areas. We also test to see if you have sealant on your grout.
Step 2 – Pre-spray the tile and grout with a special solutions made to break down grease and oils.
Step 3 – Agitate the pre-spray in the grout with a grout brush or rotary scrubbing machine if necessary
Step 4 – Rinse the pre-spray with high-pressured, hot water through our truck-mount machine.
Step 5 - Your tile is mopped and speed dried ready for use!
Step 6 – After cleaning we can Seal your grout with a high quality penetrating sealer.
Step 2 – Pre-spray the tile and grout with a special solutions made to break down grease and oils.
Step 3 – Agitate the pre-spray in the grout with a grout brush or rotary scrubbing machine if necessary
Step 4 – Rinse the pre-spray with high-pressured, hot water through our truck-mount machine.
Step 5 - Your tile is mopped and speed dried ready for use!
Step 6 – After cleaning we can Seal your grout with a high quality penetrating sealer.
Client Testimonials
Virgina R of Jacaranda Country Club
“Crystal Cleaners did a fantastic Job on my Tile and grout, He brought back all the color!”
Virginia From Venice writes
"My tile and grout look fresh and new again Thanks Crystal Cleaners!"
Sharon a property manager in Nokomis comments:
"Great service & Always right away!"
“Crystal Cleaners did a fantastic Job on my Tile and grout, He brought back all the color!”
Virginia From Venice writes
"My tile and grout look fresh and new again Thanks Crystal Cleaners!"
Sharon a property manager in Nokomis comments:
"Great service & Always right away!"
Call Bill or Joshua Colantuono (941) 485-7781
E-mail [email protected]
222 Parkview Dr Venice, Fl 34293
E-mail [email protected]
222 Parkview Dr Venice, Fl 34293